Sanding Disc Station - Sanding Outside Curves
Always sand outside curves using the sanding disc and moving the workpiece from the left side of
centre, as shown. Keep the curve pressed rmly against the sanding disc, moving the work evenly
from the left side of the sanding disc. Be sure to hold the workpiece rmly onto the surface of the
sanding-disc table.
Mitre Gauge – Disc Sander
A mitre-gauge is supplied with your sander, and can be used on the disc table, as shown. The mitre
gauge head can be set anywhere up to 60º (right or left) by loosening the lock-knob, setting the mitre
gauge head to the desired angle, and retightening the lock-knob.
Sanding Small End Grain and other small surfaces using the Mitre Gauge
Use of the mitre gauge is recommended for sanding small end surfaces on the sanding disc. Note:
Always move the workpiece across the sanding disc from the left side towards the right side, and be
sure to hold the workpiece down tightly onto the table surface.
16
To Next Page
Loading...
