Maintenance
WARNING! Turn the power switch “OFF” and disconnect the plug from the outlet prior
to adjusting or maintaining the sander. DO NOT attempt to repair or maintain the electrical
components of the motor. Take the sander to a qualied service technician for this type of
maintenance.
Maintenance Required Frequency
1. Check power cord Before each use.
2. Check sanding belts and discs for damage Before each use.
3. Check moving parts for alignment and binding issues Before each use.
4. Dress sanding surfaces As needed
5. Replace sanding belts or discs (see manual section for specics) As needed.
6. Clean and vacuum dust from the motor housing and other sander parts As needed.
7. Ball Bearings in this tool are lubricated and sealed. They require no further lubrication.
Service beyond recommended maintenance on these tools should only be performed by
an authorized, qualied technician.
17
To Next Page
Loading...
