14. DO NOT STAND ON THE TOOL. Serious injury could result if the tool tips or is
accidentally jarred. Do not store anything above or near the tool.
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant
rubber-soled footwear. Keep the floor clear of oil, scraps, and other debris.
16.MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order.
Follow the instructions for lubricating and changing accessories.
17.CHECK FOR DAMAGED PARTS. Check for misalignment, jamming, breakage, and
improper mounting of moving parts, and for any other conditions that may affect the
operation of the tool. Repair or replace any part that is damaged before using the lathe.
18.MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches, and remove
starter keys.
19.DO NOT operate the tool when under the influence of drugs, alcohol or medication that
may affect your ability to use the tool properly.
Keep this Owner's Manual in a safe place for future reference.
II. General Safety Rules (continued)
4
WARNING: DUST GENERATED FROM CERTAIN MATERIALS CAN BE HAZARDOUS TO
THE HEALTH. OPERATE THE LATHE IN A WELL-VENTILATED AREA, AND ENSURE
THAT PROPER DUST REMOVAL IS PROVIDED. WEAR A FACE MASK OR A DUST MASK
WHEN OPERATING THE LATHE.
WEAR EYE PROTECTION THAT CONFORMS WITH CSA
REQUIREMENTS.
FLYING DEBRIS can cause permanent eye damage.
Prescription eyeglasses are not an adequate substitute for proper
eye protection.
WARNING: EXPOSURE TO EXCESSIVE NOISE LEVELS CAN RESULT IN PERMANENT
HEARING LOSS. WEAR EAR PROTECTION (SAFETY EAR MUFFS OR EAR PLUGS) IN
ORDER TO REDUCE NOISE LEVELS WHEN OPERATING THE LATHE.
To Next Page
Loading...
Need help?
General
