MasterCraft MAXIMUM 54-8205-8 User Manual

AVAILABLE ACCESSORIES
Use only accessories recommended for this cutting
tool. Follow instructions that accompany accessories.
Use of improper accessories may cause injury to the
operator or damage to the Spin Saw.
Do not use any accessory unless you have completely
read the instructions or Owner’s Manual for that
accessory.
●
1
/
8
” Cutting bits
●
1
/
8
” &
3
/
32
” Rotary tool accessories
 Cutters
 Polishers
 Sanders
 Grinders
● Most ¼” shank router bits
● 3 ½” grinding discs
● 4” sanding discs
UNPACKING AND CHECKING CARTON CONTENTS
If any part is missing or damaged, do not plug the
Spin Saw into the power source until the missing or
damaged part is replaced and assembly is complete.
Carefully unpack the Spin Saw and all its components.
Compare against the “Spin Saw Components” chart.
NOTE: See Page 8 for illustration of components.
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the cutting tool.
LATERAL STYLE DRYWALL CUTTING BIT
This cutting bit has a fine spiral for removing high
volumes of fine particles when cutting (see right).
Use this cutter for cutting drywall.
GENERAL PURPOSE CUTTING BIT
This cutting bit has a coarse spiral for removing particles
when being used for general cutting (see right).
Use this general purpose cutting bit for cutting wood,
plastic and fibreglass.
SPIN SAW COMPONENTS
KEY
DESCRIPTION
QTY
Inside Carrying Case
A
Spin Saw
1
B
Removable handle with sole plate
1
C
Freehand cutting guide
1
D
Circle cutting guide
1
E
Beveling plunge router attachment
1
F
Spin Saw collet wrench
1
G
Blow moulded case
1
H
Collet wrench holder
1
I
Straight edge guide
1
J
Angle grinder attachment
1
K
Angle grinder attachment side
handle & collar
1
L
Flexible shaft
1
M
Angle Grinder Attachment Set
● 2 cutting discs
● 2 sanding discs
● 1 polishing pad
● 1 sanding disc backing pad
Owner’s Manual
1
Front Lid Storage Compartment
N
Cutter Set
●
1
/
8
” & ¼” collets
● Flexible shaft adaptor for angle
grinder
● Drywall cutting bit
● All purpose cutting bit
Flexible Shaft Accessory Set
●
3
/
32
” &
1
/
8
” collets
● Square collet
● Collet wrench
● Locking pin
20 piece
3
/
32
” Flexible Shaft Cutter
Set
● Various grinding, sanding,
cutting bits, and buffing pads
● See Page 8 for descriptions

MasterCraft MAXIMUM 54-8205-8 Specifications

General

Brand	MasterCraft
Model	MAXIMUM 54-8205-8
Category	Saw
Language	English