2017 OWNERS MANUAL / 306
Failure to operate the boat from a seated position at the helm
may result in a loss of control which could cause serious injury or
death. Do not operate the boat with the reversible seat facing the
main cockpit (aft). Always position the reversible seat facing the
bow before operating the boat. Operating the boat with the seat
facing the main cockpit (aft) could lead to loss of control of the
boat, injury or property damage.
SURF SLEEVES
Models
Optional on all boats equipped with a ZFT4 or ZFT7 tower.
X46 REVERSIBLE HELM SEAT
Models
Optional X46 Models
Purpose
The 36” wide helm seat was designed to seat up to two adults at
the helm. The seat can be reversed to face the main cockpit of
the boat when stopped. As with all MasterCraft helm seats, the
reversible helm seat includes a flip up bolster to aid in visibility while
driving. Do not operate the boat with the helm seat in the rear facing
position.
Location
The X46 Reversible Helm Seat is located at the helm.
Operation
To change the orientation of the X46 reversible helm seat, pull on
the lever mounted inside the hinge bracket to release the seat, then
flip the seat forward or aft. The bracket holding the backrest will
guide the seat into place.
Troubleshooting
Should the reversible helm seat ever bind up or get stuck in either
position, take the boat to an authorized MasterCraft dealer for
repair.
Purpose
Surf sleeves allow surf boards to be stowed during boat operation
without taking up additional space on deck. This is particularly con-
venient for surf boards which do not fit in storage compartments.
Location
Surf sleeves are mounted on top of Bimini canvas.
Operation
Slide surf boards inside one of the four pockets and snap the pro-
tective strap to secure each board. Always secure the surf boards
with the straps and be sure that the boards are fully inserted into
the sleeves, as boards can become dislodged and fall onto the
deck, potentially harming passengers. Never trailer a boat with surf
boards in the surf sleeves, even if the straps are snapped. The force
on the system could cause the straps to break and allow the boards
to come out of the sleeves.
Never tow over the road with anything in the surf sleeve, even
with the straps connected. Wind and air currents can be sucient
to break straps and/or force the surf boards or other items to
dislodge. This could result in damage to vehicles following and/or
serious injury or death to individuals in those vehicles.
GOPRO VIEWING SYSTEM
Models
X10, X20, XT23, X23, X26, X46 and XStar, as an option.
Purpose
The video cable ensures correct GoPro camera placement by dis-
playing on the 7” dash a live stream of what the camera is actively
recording. Connecting the video cable also makes it possible to
control the camera’s angle and zoom settings while it is mounted to
the boat tower
NOTE: When towing with the GoPro tower mount, tow ropes should
be mounted as indicated in the picture on the previous page. Each
GoPro viewing system has a sticker indicating where the rope
should be attached.
To Next Page
Loading...