Page 25
OPERATION
FIG. 17C
• With the tile saw running, make sure the pump is supplying
enough water to the tile saw blade.
• Let the tile saw blade build up to full speed before cutting.
• Use two hands and hold workpiece securely against table
and fence at all times. Feed the material into the tile saw
blade.
• When the cut is made, turn the tile saw off. Wait for the tile
saw blade to come to a complete stop before removing
any part of the workpiece.
• To prevent accidents, turn off the tile saw and unplug the
tile saw from its electrical outlet after use. Clean, then
store the tile saw indoors out of children’s reach.
STRAIGHT CUT
MITER CUT
BEVEL CUT
To Next Page
Loading...
