Masterpro ROCKET 700 - Using the Appliance; Step 6: Set Cooking Parameters

6 7
EN EN
Note:
When using the air fryer for the rst time, a slight smoke or
odour may be emitted. This is normal and will soon subside. Allow
for sufcient ventilation around the air fryer during use. It’s advised to
run the air fryer without food for approx. 10 minutes before rst use;
this will prevent the initial smoke or odour from affecting the
taste of the food.
FUNCTIONS
AIR FRYER, FRIES, WINGS, BACON, FISH, VEGETABLES, BAKE,
CHICKEN, BROIL, PIZZA, KEEP WARM, DEFROST.
Icons Preset Time Temp.
Air fryer 20 min. 200°C
Fries 15 min. 200°C
Wings 25 min. 200°C
Bacon 6 min. 190°C
Fish 10 min. 190°C
Vegetables 20 min. 200°C
Bake 25 min. 170°C
Chicken 25 min. 200°C
Broil 12 min. 200°C
Pizza 15 min. 180°C
Keep warm 15 min. 150°C
Defrost 30 min. 90°C
USING THE APPLIANCE
Using instruction for this air fryer.
STEP 1:
Plug in and switch on the air fryer at the mains power
supply; the air fryer will beep and the power button will illuminate to
indicate that the unit is plugged in.
STEP 2:
Tap the power button to switch on the air fryer; the LED
display will show “180°C“ and 15MIN”, indicating that the time and
temperature are ready to be programmed.
STEP 3:
Following the instructions in the section entitled‘Using the
Digital Control Panel” , preheat the air fryer for approx.5 minutes.
Use + or - to increase or decrease the time or temperature if
required.
STEP 4:
Once preheated, remove the cooking compartment by
pulling it out of the air fryer using the handle. Place the cooking
compartment onto a at, stable, heat-resistan surface. Check that
the plastic button cover is over the basket release button to avoid it
from being released accidentally.
STEP 5:
Place the ingredients into the non-stick coated cooking
basket and then slide the cooking compartment back into the air fryer
main unit to close it.
STEP 6:
Use the digital control panel to set the cooking time
and temperature as required for the ingredients. The time and
temperature can also be set using the
“MODE”
buttons. This will
automatically cycle between time and temperature presets for
cooking various foods. These presets can then be adjusted using
+ or – to increase or decrease the time or temperature as required.
Then press the power button to begin cooking.