Manual Matco A400
12
3.4.4 Messages
This screen shows malfunctions. They need to be resolved before the machine can be restarted.
Machine position not at zero,
Film carriage, turntable or
sweeping arm
Press and hold the home position button until all
components are back in the basic position and the
start button flashes.
Machine position not on
automatic
In the main menu, set the position to automatic
operation.
Loose lifting strap, film
carriage hangs in fall arrest
device
Raise the film carriage in manual mode until it is
tight again.
Film carriage runs in the
wrong direction
Call Matco International for support.
Film breakage or film roll
finished
Insert new roll or fix reason for film breakage
Base protection switched on
Remove obstruction under base protection.
Fault of freq. controller
Reset controller on HMI. If this does not work, turn
off the machine for 1 minute and restart it. In case
of no result, call Matco International.
To Next Page
Loading...