Attention:
Hazardous electrical voltage. Failure to observe warnings and safety measures
may result in a fatal accident, personal injury or damage to equipment.
- Connecting to a power source:
• The preferred way to connect the installation is via a power cable with a plug, connected to an
earthed mains socked that is protected by a circuit breaker or fuse.
• The power supply must, in principle, comply with applicable requirements regarding
acceptable voltage variations, ripple, attenuation of higher harmonics, etc.
4.7 Mounting
Attention:
All of these activities may only be performed under the supervision of
qualified personnel from the manufacturer or an authorised representative!
- The concrete floor must be completely flat and horizontal within the tolerances set by the
installation
- Anchor machine parts to concrete floor.
To Next Page
Loading...