Matest C314 - Page 2

Rev. Descrizione Redatto/Gestito Approvato Cod.Ident. Pagine Data Em.
03 Manuale Istruzioni Ufficio Tecnico Resp.Tecnico C314.M01.EN.03
2/18
03/2009
2
GENERAL INDEX
Chapter 1 GENERAL INFORMATION
1.1 GENERAL FEATURES
1.2 IDENTIFICATION
1.3 APPLICATIONS
1.4 STRUCTURE AND OPERATING OF THE MACHINE
Chapter 2 SAFETY INFORMATION
2.1 GENERAL SAFETY STANDARDS
2.2 DANGEROUS PARTS AND RESIDUAL RISKS
2.3 NOISE
Chapter 3 INSTALLATION
3.1 LIFTING
3.2 UNPACKING
3.3 POSITIONING
3.4 ELECTRIC CONNECTION
Chapter 4 MACHINE FEATURES
4.1 FEATURES OF THE APPLIANCE
4.2 CALIBRATION
Chapter 5 OPERATOR INTERFACE
5.1 CONTROLS AND MESSAGES
Chapter 6 USE
6.1 SWITCHING ON THE APPLIANCE
6.2 SETTING UP THE APPLIANCE
6.3 STANDARD STARTING
6.4 STANDARD STOP
6.5 EMERGENCY STOP
6.6 SWITCHING OFF
6.7 TRIAL STARTING
6.8 EXAMPLE OF OPERATING
Chapter 7 MAINTENANCE
7.1 ROUTINE MAINTENANCE
7.2 CALIBRATION
7.3 SPECIAL MAINTENANCE
Chapter 8 DIAGNOSIS
Chapter 9 SCRAPPING
9.1 SETTING ASIDE
9.2 SCRAPPING
Chapter 10 ENCLOSURES
A GENERAL VIEW OF THE CONTROL PANEL
B ELECTRICAL LAYOUTS
EEC CONFORMITY DECLARATION (ONLY FOR EEC COUNTRIES)
ATTENTION All indications given in this manual must be followed carefully. In case they are not the warranty
terms will not be considered valid anymore.