Rev. Descrizione Redatto/Gestito Approvato Cod.Ident. Pagine Data Em.
03 Manuale Istruzioni Ufficio Tecnico Resp.Tecnico C314.M01.EN.03
3/18
03/2009
3
Chapter 1 GENERAL INFORMATION
1.1 GENERAL FEATURES
• This manual id addressed to the carrier, the installer, the user, the maintenance operator, and the scrapping
operator.
• Please read it carefully because it informs you about the operating of the machine in safety conditions.
• This manual has to be considered a part of the product and concerns only the machine it is delivered with.
• Keep the manual in order during the whole life of the appliance to consult it for any needs.
• In case of sale, the manual and its enclosures should be given together with the machine.
• The manufacturer assumes no liability for any damages caused by a misuse of the machine.
• The manufacturer has the right to modify this technical literature as well as the machines this refers to without any
previous notice.
• Messages meaning:
ATTENTION
It shows the procedures that can damage seriously the machine if they are not followed carefully
1.2 IDENTIFICATION
MANUFACTURER IDENTIFICATION: See the cover page
MACHINE IDENTIFICATION: See the plate on the machine
1.3 APPLICATION
The appliance described in this manual is made for the execution of ageing tests, accelerated maturation tests, freezing
and unfreezing tests on concrete specimens.
This appliance has to be used only for the aim it has been projected and manufactured for.
Any other use of the machine is not permitted.
ATTENTION
The instructions given in this operating manual are only made for the right use of the appliance. To carry
out the test in the right way, the user must refer to the specific standards in force for the test itself.
1.4 STRUCTURE AND OPERATING OF THE MACHINE
This appliance is composed by an insulated chamber with front door for the introduction of the specimens into the inside
chamber. The chamber is equipped with mobile shelves where specimens can be positioned.
A group of heating elements allows the heating of the temperature.
A freezing system allows the cooling of the temperature.
A system producing water steam allows setting the humidity required.
Regulators that check and keep the temperature and the humidity inside the chamber check all these systems.
If further information is required, get in touch with the dealer or the manufacturer.
Chapter 2 SAFETY INFORMATION
2.1 GENERAL SAFETY STANDARDS
• The use, lifting, installation, maintenance and scrapping of the machine are allowed only to QUALIFIED
STAFF.
Qualified staffs is composed by people who are authorised by the safety responsible to do any activities due to their
experience and acknowledgement of the operating of the machine and of the standards, rules and actions.
The user must be carefully taught about the operating of the machine to avoid any misuse of it and about the safety
devices, which the machine could be eventually equipped with. The safety devices will have to be kept always
assembled and to be daily checked.
The manufacturers offer training and assume no liability for any damages due to a misuse of the machine by an
unskilled staff.
• The manufacturer recommends following carefully the instructions and procedures of the operating manual and the
safety standards concerning the safety devices and the general rules of the work environment.
• Verify the accordance of the machine to the standards in force in the State where the machine has to be installed.
• The operating manual must be carefully read by the safety responsible, by the operators and maintenance engineers.
It must always be kept near the machine in order to be able to read it any times it will be necessary.
To Next Page
Loading...