Rev. Descrizione Redatto/Gestito Approvato Cod.Ident. Pagine Data Em.
03 Manuale Istruzioni Ufficio Tecnico Resp.Tecnico C314.M01.EN.03
4/18
03/2009
4
• Any tampering or modifications of the machine (electric, mechanical etc.) that are not allowed by a written agreement
of the manufacturer must be considered as not permitted and the manufacturer will not accept to be charged for any
damages.
• The removal or the tampering of the safety devices will be an infringement to the EEC Safety Standards. The
manufacturer assumes no liability for any damages.
• The machine has to be installed in places safe from fire and explosions.
• We do recommend using only original spare parts and accessories; on the contrary the manufacturer assumes no
liability.
• Be careful that any dangerous situations won't happen during the working; stop immediately the machine in the event
that it will not work properly and ask the manufacturer or the Authorised Service Staff of the dealer at once.
The manufacturer assumes no liability for any damages to people, things and animals caused by the non-compliance of
the instruction manual.
2.2 DANGEROUS PARTS AND RESIDUAL RISKS
The dangerous place is the space inside and around the machine where the operator could be wounded or damaged.
During some procedures the operator could face some risks of danger.
All these risks can be eliminated, if all procedures explained in the manual are followed and if individual safety devices
are properly used.
DANGER
120° C. hot steam can be expelled during the working of the appliance from the emergency water drain
pipe on the back lower part of the chamber.
Do not stay near to the drainpipe and ensure that the installation has been made following the
indications given in this manual in order to collect and expel the steam without any risk for people and
things around the appliance.
DANGER
Do not introduce persons, animals or objects other than specimens to be used for the test inside the
chamber.
DANGER
Do not wash the appliance with water sprays
The manufacturer assumes no liability for any damages to people and things due to a lack of observance of the
instructions and the use of adequate personal safety devices (Following the local laws against the accidents).
2.3 NOISE
The indicated levels of noise are not necessarily safety levels for the operator.
The exposure levels of the operator are obviously related to the emission levels of the appliance, but other factors
influence the exposure levels as the time of exposure, the environment, other appliances installed near to the appliance
etc.
The exposure levels permit to value the damages that could be caused by the noise
Acoustical pressure level equivalent Laeq at 1 m distance 56 dB(A)
Acoustical power emitted by the appliance LWA………….. 61 dB(A)
Standard above data are referred EN ISO 3746
DANGER
The continuous use of the machine together with other noisy appliances could cause a high level of
exposure to the noise. If the daily exposure of the operator is equal or higher than 85 dB(A), Safety
Devices as headphone are suggested to be worn.
If the daily exposure is equal or higher than 90 dB(A), the use of the Safety Device is compulsory.
For further information consult the standards of the country where the machine has been installed.
Chapter 3 INSTALLATION
DANGER Consult 2.2 DANGEROUS PARTS AND RESIDUAL RISKS before proceeding
3.1 LIFTING
The operating instructions must be respected during:
• The lifting and the storing
• The first installation
To Next Page
Loading...