Rev. Descrizione Redatto/Gestito Approvato Cod.Ident. Pagine Data Em.
03 Manuale Istruzioni Ufficio Tecnico Resp.Tecnico C314.M01.EN.03
9/18
03/2009
9
• Act on UP or DOWN buttons of the temperature controller in order to set the value of 35° C.
• Activate the “ SEL / ENT “ button to confirm the data.
In this condition the upper display gives the actual temperature(or humidity) inside the chamber while the lower
display gives the programmed value.
• Act on UP or DOWN buttons of the moisture controller to set the value of 50
• Activate the “ SEL / ENT “ button to confirm.
In this condition the upper display gives the actual temperature(or humidity) percentage inside the chamber
while the lower display gives the programmed percentage.
• Push the “Ventilation” button in order to turn on the signal lamp referring to it.
With this operation the working of the whole control of the chamber will be on.
• Push the “Temperature” button in order to turn on the signal lamp referring to it.
With this operation the working of the temperature control will be on.
• Push the “Climax” button in order to turn on the signal lamp referring to it.
With this operation the working of the humidity control will be on.
Starting form this very moment the control of the different processes starts and works in order to keep the temperature
and humidity values that have been set.
The reaching of the values that have been set can be checked by comparing the values given on the upper displays (real
value inside the chamber) and the lower displays (set value).
To stop the temperature control, push the “Temperature” button (the signal light will be off).
To stop the humidity control, push the “Climax” button (the signal lamp will be off).
To stop the whole control process, push on the “Ventilation” button (the signal lamp will be off).
Chapter 7 MAINTENANCE
DANGER
All the maintenance operations must be carried out with the machine turned off and unplugged from the
knife switch.
DANGER
Skilled operators instructed about the purposes the machine is made for must carry any kind of
maintenance operations concerning the components of the machine and of the electric components,
even those that may seem very simple.
7.1 ROUTINE MAINTENANCE
• Clean the condenser (positioned on the upper part of the chamber) at least once per month from dust and dirt using a
dry brush.
NB : A bad maintenance of the condenser will negatively affect the Climatic Chamber yield as well as its
good functioning and may also cause irreparable failures.i
• Clean the inner space once every six months at least, by following the below operating instructions:
- Switch the equipment off by means of the A main switch
- Soup the inner spaces up and remove the possible impurities by means of a dry cloth.
• In order to maintain the efficiency of the machine, clean periodically all its parts. Avoid the use of solvents which
damage the painted parts as well as parts made by synthetic materials.
• Check periodically that the salt of the decalcificator – when assembled on the equipment – are in good conditions.
7.2 CALIBRATION
It is recommended to carry out a periodical calibration control, by official institutions in charge, according to
law now in force.
7.3 SPECIAL MAINTENANCE
To Next Page
Loading...