Matest E094 - Emergency Stop Function; Restarting After Emergency Stop; Safety System Stops; Appliance Functioning Modes

11
6.4
PREPARATION AND POSITIONING OF THE MORTAR
The preparation and the positioning of the material to be tested may be effected in several ways
depending on the nature of the tests. For a correct procedure in the specimen handling, refer to the
Standards ruling the test to be effected.
6.5
EMERGENCY STOP
In the event of an emergency, a sudden stop of the test is possible by positioning the Main Switch
(B13/C13) on “0”.
ATTENTION
It’s always worth reminding that the test interruption causes its cancellation.
6.6
START AFTER AN EMERGENCY STOP
DANGER
Before starting the appliance again, find and eliminate the problem, which caused the
need for an emergency stop.
To start the machine again, put the Main Switch (B13/C13) on the “I” position. This will reset the appliance
normal functions.
6.7
STOP CONTROLLED BY SAFETY SYSTEMS
The test execution could be interrupted by the safety systems; in fact they are activated in case of
working problems. This Mixer is supplied with the following systems:
STOP CAUSED BY THE MICRO SWITCH FOR DOOR OPENING.
The Mixer E095 has got a safety door (B16), which is equipped with a security micro switch. In fact during
the test execution the operator cannot open the door since the micro is activated by the door opening and
automatically disconnects the feeding to the electric motor (B4 / C4).
6.8
APPLIANCE FUNCTIONING
DANGER
Never try to use the appliance before reading and learning this manual in all its parts.
We describe hereunder the correct procedure for both models:
MIXER E095 – CE MODEL
1. Switch on the mixer (for further details, consult the Chapter “SWITCHING ON THE APPLIANCE” in this
manual).
2. Choose the slow or fast rotation according to your needs. Use the Selector (E1).
3. Push the START button (E2) to start the beater rotation (B1 / C1). During the mixer working, it is also
possible to change the selected speed acting on the special selector (E1) and without interrupting
the present turning.
To end the rotation cycle, push the STOP button (E3).
MIXER E094 – STANDARD MODEL
4. Switch on the mixer (for further details, consult the Chapter “SWITCHING ON THE APPLIANCE” in this
manual).
ATTENTION
Before switching on the appliance, ensure that:
- The bowl is correctly located in its housing (B11 / C11).
- The selector (E4) is on the middle position of “STOP” (see enclosure E for
further details).
5. Choose the slow or fast rotation according to your needs. Use the Selector (E4). The rotation starts
immediately after the selection. During the mixer working, it is also possible to change the selected
speed acting on the special selector (E4) and without interrupting the present turning.
To end the rotation cycle, turn the selector (E4) on the middle position “STOP”.