Matest E094 - Switching Off the Appliance

12
6.9
SWITCHING OFF THE APPLIANCE
After a test series, follow these instructions to switch off the appliance:
1. Verify that there are no residuals or dirty either in the bowl (B14/C14) or on the beater (B1/C1), if
necessary clean the components thoroughly.
2. Switch off the Mixer, by positioning the Main Switch (B13/C13) on the “0”.
6.10
TRIAL STARTING
Before beginning the standard use of this machine, check its perfect working conditions by carrying out at
least one complete empty cycle.
ATTENTION
Never start the beater rotation if the bowl isn’t at its
place. The rotating components of
the Mixer could be seriously damaged.
In case of problems during this test cycle, see Chapter “DIAGNOSIS“.
If neither the instructions given in this manual are not able to solve the problem, please contact our After
Sale Service or ask your local distributors for information about the repair procedures and diagnosis
service.
CHAPTER 7
MAINTENANCE
DANGER
Consult “DANGEROUS PARTS AND RESIDUAL RISKS” before proceeding.
DANGER
All the maintenance operations must be carried out with the machine turned off and
unplugged from the knife switch.
DANGER
Skilled operators instructed about the purposes the machine is made for must carry any
kind of maintenance operations concerning the components of the machine and of the
electric components, even those that may seem very simple.
DANGER
Only the use of original spare parts is allowed. The Manufacturer assumes no liability in
the event that non – original spare parts are used.
7.1
ROUTINE MAINTENANCE
In order to maintain good working of the machine for a long time, clean periodically all the parts and oil
the parts that are not painted.
Do not use solvents, which may damage the painting and the parts made of synthetic materials.
Ensure that all procedures described in the Chapter “PERIODICAL INSPECTIONS” are correctly and
punctually executed. This care will help preventing failures and dysfunctions.
7.2
SPECIAL MAINTENANCE
In case of special maintenance operations (repairs, replacement of parts and any other operation not
described in this manual) ask directly to the manufacturer.
7.3
CALIBRATION
Proceed with a check of the calibration by officially recognised institutes following the standards in force.
7.4
PERIODICAL INSPECTIONS
Ensure that all procedures described in this Chapter are correctly and punctually executed. This care will
help preventing failures and dysfunctions.
OPERATION
CLEANING AND GREASING OF THE ROTATION PIN (B6 / C6)
PROCEDURE
The rotation pin must be cleaned from every dust residual and oil
ed every 100 working
hours.
FREQUENCY
EVERY 100 WORKING HOURS