Matest E094 - Dangerous Parts and Risks

5
2.3
DANGEROUS PARTS AND RESIDUAL RISK
The dangerous place is the space inside and around the machine where the operator could be wounded
or damaged.
During some procedures the operator could face some risks of danger.
The risks can be eliminated following carefully the procedures written in this manual and using suitable
safety devices.
ATTENTION
In case the manufacturer does not make the installation, use only people instructed on
the installation of the specific appliance.
GENERAL INFO
 Before starting the standard use of the equipment, ensure that all the components are in
good working conditions, check there are no detective or damaged parts. If necessary repair
or replace any damaged part.
 Pay attention to the possibility of electric shocks (both direct or indirect), which could be caused by
failures in the electric system.
 Do not subject the appliance to impacts or shocks.
 Do not expose the appliance to fire, extreme temperatures or weld splatter.
 Avoid corrosive substances to come in touch with the appliance.
 Do not wash the machine using water spray.
DURING THE USE
 In order to grant the maximum-security level for the operator, do not touch any moving part
of the appliance during the test execution and wear the convenient protection devices.
 Never wear large clothes, ties, watches, chains, and so on, which may entangle into the moving
parts of the machine.
DURING THE LIFTING
 During the lifting take care that the machine is conveniently held and secured and that it cannot slide.
 Do not stand in a direct line with the application of force. Do not allow people entrance under loads
that are no conveniently supported by mechanical means.
 Never subject bars or cylinders to impacts or shocks.
RISK OR DANGER
PROTECTION DEVICES
FINGER SQUEEZE REINFORCED GLOVES
CUTS OR ABRASIONS REINFORCED GLOVES
The manufacturer a
ssumes no liability for any damages to people and things due to a lack of
observance of the instructions and the use of the safety devices.
2.4
NOISE
The indicated levels of noise are not necessarily safety levels for the operator.
The exposure levels of the operator are obviously related to the emission levels of the appliance, but
other factors influence the exposure levels as the time of exposure, the environment, other appliances
installed near to the appliance etc.
The exposure levels permit to value the damages that could be caused by the noise.
Acoustical pressure level equivalent
Laeq
at 1 m. distance
52
dB(A)
Acoustical power emitted by the appliance
LWA
57
dB(A)
Standard above data are referred
EN ISO 3746
DANGER
The continuous use of the
machine together with other noisy appliances could cause a
high level of exposure to the noise. If the daily exposure of the operator is equal or
higher than 85 dB(A), Safety Devices as headphone are suggested to be worn.
If the daily exposure is equal or higher than 90 dB(A), the use of the Safety Device is
compulsory.
For further information consult the standards of the country where the machine has
been installed.