SETU VTEP configuration guide for Elastix Page | 5
In Trunk Name field configure Type as VTEP
In CID Options field configure as Allow Any CID
Configure Maximum Channels as 8
In Dialed Number Manipulation field configure desired number pattern which has to be
routed via VTEP ( 1. Used in this example, all Outgoing numbers with prefix 1 has to be
routed via VTEP)
In Outgoing Settings, configure Trunk Name as vtep.
Configure PEER Details
o host=***provider ip address***
provider ip address is the IP address of VTEP. (i.e. 192.168.51.238)
o type=peer
Peer to Peer trunk between VTEP and Elastix
o dtmfmode=rfc2833
DTMF detection and Out-dial mode is set to rfc2833(OUTBAND)
Click on Submit changes.
To Next Page
Loading...