49
8.20 TESTING THE ASCENT TRAINER
ONCE THE UNIT OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED AND
PROPERLY PLACED ON THE FLOOR, USE THE FOLLOWING INSTRUCTIONS TO TEST
THE MACHINE:
1) Without hitting start or entering any exercise modes, stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
2) After stopping movement, press the green GO key and begin using the machine.
3) Grasp the hand grips to check for proper heart rate response.
8) If the Ascent Trainer has had an incline motor replaced, or if this is the initial installation, calibrate the lift motors (see Section 4.8).
CHAPTER 8: PART REPLACEMENT GUIDE
To Next Page
Loading...
