CHAPTER 5: mX-t5X overlay Description / programing / engineering moDe
12
5.7 MANAGER SCREENS EXCEPTIONS/DETAILS
Below is a list of functions for each Manager Setting. Exceptions will be noted in
the description for each manager setting:
P0 MAXIMUM TIME
(EDIT)
This variable controls the program maximum time.
Active variable display in the time seven segment display.
Numeric entry is active.
P1 DEFAULT TIME
(EDIT)
This variable controls the default program time.
Active variable displayed in the time seven segment display.
Numeric entry is active.
P2 DEFAULT LEvEL
(EDIT)
This variable controls the default program level (may be eliminated in final product).
Active variable displayed in the time seven segment display.
Numeric entry is active.
P3 DEFAULT AGE
(EDIT)
The variable controls the default users age used in the goal heart rate calculations.
Active variable displayed in the time seven segment display.
Numeric entry is active.
P4 DEFAULT WEIGHT
(EDIT)
This variable controls the default users age used in the calorie calculations.
Active variable displayed in the time seven segment display.
Displayed in native unites (kilogram or pounds)
Numeric entry is active.
P5 ACCUMULATED DISTANCE
This variable displayed in the time seven segment disply.
Accumulated distance is not editable, for display only.
Displayed in native unites (kilometers or miles)
Holding the start key resets the accumulated distance.
P6 ACCUMULATED TIME
This variable displayed in the time seven segment disply.
Accumulated time is not editable, for display only.
Holding the start key resets the accumulated distance.
P7 SOFTWARE vERSION
Active variable displayed in the time seven segment display.
Accumulated distance is not editable, for display only.
P8 START SPEED
(EDIT)
Controls the starting speed for all programs (minimum speed not affected).
Active variable displayed in the time seven segment display.
Displayed in native unites (kilometers per hour or miles per hour).
Reverts to default value on unit change.
Numeric entry is active.
P9 MAXIMUM SPEED
(EDIT)
Controls the maximum speed for all programs.
Active variable displayed in the time seven segment display.
Displayed in native unites (kilometers per hour or miles per hour)
Reverts to default value on unit change.
Numeric entry is active.
5.6 ENGINEERING MODE
Manager screens allow the viewing and editing of variables that would be
necessary for a club operator/manager to customize. Unless otherwise noted
manager screens consist of the initial screen, the editing or action screen and
the saving screen. The initial screen displays the variable type and in most
cases the current value. Edit or actions screens are where the editing of the
variable take place. The saving screen indicates the variable is being saved.
To access the Manager Settings press and hold the ELEvATION DOWN and
SPEED UP bottons for three seconds.
Use the ELEvATION or
SPEED UP and DOWN arrows to scroll through the
different manager setting.
Press
SELECT to edit the selected manager setting.
Use the ELEvATION or SPEED UP and DOWN arrows to set the variable.
Press
START to save the seected variable.
NOTE: SAvING all appear in the 7 segment window when the variavle is being
saved to memeory.
To Next Page
Loading...
