Matrix COMMERCIAL SERIES TREADMILL - 6.4 MX-T3 x;T3 xi Assembly Steps (Part 2 - Final)

17
CHAPTER 6: MX-T3X / T3Xi TreaDmill specifications, parts, anD assembly guiDes
6.4 MX-T3X / MX-T3XI MODEL ASSEMBLY STEPS
FINAL ASSEMBLY
AUTO CHECK
• Press and hold both incline “UP” and speed “DOWN“ buttons simultaneously for 3 seconds .Then the “ENGINEERING MODE” is shown onto the console.
• Press the incline “UP” button to find the “AUTO CHECK” screen.
• Press the incline “START” button and then, the treadmill will run the auto check function automatically. This will take around 3 minutes to run.
• After auto check is complete “AUTO CHECK OK” will show on the console. Then, press EMERGENCY STOP key to back to initial starting screen.
STEP 3
STEP 4
Z53
Z53
06'_Treadmills_M.indd 21 7/18/06 4:00:08 PM