1. Do not install the device in extremely hot temperature or under
direct sunlight on turnstile or at extra bright places. This may affect
the LCD and finger print sensor of device. You can do indoor
installation or on the turnstile under the roof as shown in Figure a.
2. You can mount the device on a flat surface such as a wall or near
the elevator, close to the access point (door) with surface wiring or
concealed wiring as shown in Figure c.
3. Recommended height from ground level is upto 4.5 feet.
4. Do not install on unstable surfaces, near volatile inflammable
materials, areas where volatile gas is created, where ferromagnetic
field or noise is induced, where static is created, such as desks made
of plastics, carpets.
5. Do not install the device in outdoor areas which may be exposed
to rain, cold and dust. You can do indoor installation or on the
turnstile under the roof as shown in Figure b.
2
Next
Level
Pre-Installation Safety Instructions
Figure a
Figure b
Figure c
To Next Page
Loading...
Need help?
General
