3
ENGLISH
UNPACKING
Unpack the equipment where you will be using it. Place the carton
on a level flat surface. It is recommended that you place a protective
covering on your floor. Never open box when it is on its side.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly
and usage. Please do not wipe this o. If you have diculty,
a light application of lithium grease is recommended.
WARNING!
There are several areas during the assembly process that special
attention must be paid. It is very important to follow the assembly
instructions correctly and to make sure all parts are firmly tightened.
If the assembly instructions are not followed correctly, the
equipment could have parts that are not tightened and will seem
loose and may cause irritating noises. To prevent damage to the
equipment, assembly instructions must be reviewed and followed.
NEED HELP?
If you have questions or if there are any missing
parts, contact Customer Tech Support.
ASSEMBLY
TOOLS REQUIRED:
F 3 mm Allen Wrench
F 5 mm Allen Wrench
F 10 mm Allen Wrench
F Flat Wrench (15mm/17mm 325L)
F Phillips Screwdriver
PARTS INCLUDED:
F 1 Main Frame
F 1 Front Stabilizer Tube
F 1 Rear Stabilizer Tube
F 1 Handlebar Set
F 1 Transport Handle
F 1 Bicycle Saddle
F 2 Pedals
F 1 Console
F 1 Hardware Kit
ATTENTION WARNING
SIÈGE : TENEZ-VOUS À UNE MAIN EN
RÉGLANT LA HAUTEUR. ASSUREZ-VOUS
QUE LA FIXATION EST BIEN EN PLACE
AVANT DE COMMENCER.
UTILISEZ L’APPAREIL D’ENTRAÎNEMENT
FIXE DANS UN ENVIRONNEMENT
SUPERVISÉ SOUS LA SURVEILLANCE
DIRECTE D’UN INSTRUCTEUR FORMÉ.
INSTALLEZ ET UTILISEZ LE VÉLO
D'APPARTEMENT SUR UNE
SURFACE PLANE SOLIDE.
SEAT : HOLD WITH ONE HAND WHILE
ADJUSTING HEIGHT. ENSURE CLAMP
IS FULLY ENGAGED PRIOR TO USE.
USE THE STATIONARY TRAINING
EQUIPMENT IN A SUPERVISED
ENVIRONMENT UNDER THE DIRECT
SUPERVISION OF A TRAINED
INSTRUCTOR.
SET UP AND OPERATE THE
STATIONARY EXERCISE BICYCLE
ON A SOLID LEVEL
SURFACE.
FRAME SERIAL NUMBER
CONSOLE SERIAL NUMBER
MODEL: CXV MATRIX VIRTUAL TRAINING CYCLE
* Use the information above when calling for service.
To Next Page
Loading...
