23
ASSEMBLY PHASES
1) Positioning of the solarium
Position the support base of the solar group, which consists of the two semi-circles, on the ! oor at the given
distances from the walls indicated on pg. 19.
After having installed the two solar groups D and E as indicated above " x the metal " nishing in the center of
the two rings on the inferior part, (" g 3) before positing the solar group E
N.B.: Ensure that the • oor is able to support the weight of the solarium and is perfectly level.
metal " nishing
inferior center
2) Fitting the central horizontally pivoted solar groups upper and lower parts PB/PE
Before " tting the lower solar group PE (lower panel with 5 lamps) ensure that the two pins, (see " g. 4) situated
at the extremities of the foot end, are unscrewed from the inside (opening in sequence the Plexiglas door and
then removing the " rst re! ector towards the foot end), so as to reduce to a minimum the lenght of the panel.
Fixing pin inside panel
Pivot for panel
movement
After this insert the pin at the head end, (see " g. n° 5), ensuring that the nylon bush has already been inserted
into the pivot, in the hole situated on the lower support ring; then align the two pin pivos at the foot end with
the holes on the balance rail and secure them with screw, from the inner side, so as to complete the mechanical
" xing of the panel.
Fig. 4
Fig. 3
ONLY FOR INFORMATION
www.isoitalia.us
To Next Page
Loading...