Matrix ROWER-02 - ECB Replacement

18
9.3 ECB REPLACEMENT
CHAPTER 9: PARTS REPLACEMENT GUIDE
1) Remove the 3 screws holding right covert to the frame (Figure A).
2) Remove the 3 screws holding left covert to the frame (Figure B).
3) Remove the spring (Figure C).
4) Remove the 2 screws holding the ECB to the frame (Figure D).
5) Remove the tension wire (Figure E).
6) Before fixing the 2 screws of ECB, please make sure the flywheel is in middle of the 2 magnets (Figure F).
FIGURE C
FIGURE D
FIGURE A
FIGURE B
FIGURE E
FIGURE F