11 Matrix SATATYA PARAM NVR Quick Start
• Use the power cord which is supplied along with the equipment. The product should be
operated with appropriate power voltage supply as mentioned in the specification sheet.
Ensure adequate earthing at the installation site.
• Do not touch the product with wet hands. Equipment must be installed by a trained
professional.
• Prevent metallic, foreign or liquid substances from getting inside the product. This includes
insecticide or flammable cleaning spray.
• Make sure in the Rack there is minimum 1-2 inches air gap between two systems (bottom
and top). Vent holes are provided in the system for air ventilation, make sure there is no
obstruction to block it.
• Make sure the ambient temperature for the systems is below operating temperature of the
system (40 degree centigrade) day and night.
• Ensure appropriate mains filtering and UPS are used in areas where the power source is
susceptible. Damage through power source fluctuations, spikes, etc. is not covered by
warranty.
• Do not cut off the power or move the unit when hard drives are operating. Doing so may
cause damage and loss of data.
• Make sure you have complete the wiring and installation of all the devices you want to
connect to SATATYA PARAM NVR.
To Next Page
Loading...
Need help?
General
