Matrix SATATYA PARAM NVR Quick Start 10
Installing SATATYA PARAM
NVR
Package Contents
• SATATYA PARAM NVR unit
• 2 qty 220V-15A Power Cable
• 2 qty Sliding Rails for Rack installation
• 4 qty Rack Installation Screws (plus flat head)
• 6 qty Inner Rack Installation Screws (plus circular head)
• 8 qty Outer Rack Installation Screws (plus circular head)
• 32 qty HDD Installation Screws (plus circular head)
Things You Will Need
• A Power Hand Drill
• A Wire Stripper
• Insulation Tape
• A Screwdriver set
• Cameras (IP Cameras, PTZ cameras).
• Monitors with the appropriate cables to connect.
• At least one SATA Hard Disk (upto 18TB), if you want to record on a hard disk in the SATATYA
PARAM NVR. You can install eight hard disks.
• A USB Mouse or Keyboard (Wired or Wireless) to operate the SATATYA PARAM NVR, if
required.
• A personal computer or a LAN computer to access the Admin Client or the Smart Client.
• An Ethernet cable to connect to a computer/LAN/WAN (over a DSL Modem or Router).
• A rack to mount the SATATYA PARAM NVR in a rack.
Safety Instructions
• The Matrix device is intended for indoor use and can only be Rack Mounted. Equipment must
thus be installed into a controlled, dry, clean and secure environment where temperature and
humidity are within product specifications.
• Examine site conditions prior to installation. Notify the person concerned if unsuitable
conditions are encountered. Do not start installation until site conditions are acceptable.
To Next Page
Loading...
