Matrix T1x - Page 6

6
5) Remove the plastic covers (Figure 15), and lubricate the ball joint (Figure 16) where the Link Arm and
Vertical Handlebar join together. A grease gun, with a needle fitting adapter is required for this (Matrix
recommends using Superlube brand grease with PTFE {Teflon} additive).
Figure 15 Figure 16
6) Ascent Trainers only – Remove the back plastic covers (Figures 17 & 18), and lubricate the Acme screw
on the left and right incline motors (Matrix recommends using Superlube brand grease with PTFE
{Teflon} additive).
Figure 17 Figure 18
7) I5X Incline Ellipticals only – Start the machine and raise the incline setting to the maximum height. Turn
the power switch off at the front of the machine to prevent the machine from lowering accidentally.
Remove the rear stabilizer cover (Figures 19 & 20), the rear roller end cap (Figure 21) and the center cover
(Figure 22). Lubricate the incline motor Acme screw under the center of the frame (Matrix recommends
using Superlube brand grease with PTFE {Teflon} additive).
Figure 19 Figure 20