Engineering screens allow the viewing and editing of variables that would be necessary for
a club operator/manager to customize. Unless otherwise noted engineering screens consist
of the initial screen, the editing or action screen and the saving screen. The initial screen
displays the variable type and in most cases the current value. Edit or action screens are
where the editing of the variable(s) take place. The saving screen indicates the variable(s)
To access the Engineering screens press and hold the
buttons for three seconds. The display will now display 'Engineering Mode'.
arrows to scroll through the different engineering
arrows to set the variable.
to save the selected variable.
3.3 MANAGER SCREENS EXCEPTIONS/DETAILS
Below is a list of functions for each
. Exceptions will be noted in the
This variable controls the low limit for the speed of the treadmill.
This variable controls the high limit for the speed of the treadmill.
This variable controls the middle limit for the speed of the treadmill.
3.0 OVERLAY DESCRIPTION AND CUSTOM SETTINGS
Simple program view and selection buttons.
One touch Start and Quick Start
To confirm each program setting
key once to pause the program for 2 minutes. During the 2 minute
key to continue running the program, or else the machine will
reset automatically. Also, you can press and hold the
key to reset the treadmill.
Easy information and elevation selection.
Easy information and speed selection.
To stop all functions running
Press the Speed Keys’ numbers to input program Time, Weight,
To cancel the numbers entered by the Speed Keys numbers
To confirm each program setting
To Next Page
Loading...
