120
10.8 NETPULSE & AM SETTING UP SOP
CHAPTER 10: TREADMILL SPECIFICATIONS AND ASSEMBLY GUIDE
4. Connect 7xi Units to gateway server via Ethernet cables
B - Wireless connecting solution
1. Prepare site for local server and internet connection
a. Find a secure location (like an AV closet or a server room) for the gateway and related network equipment.
b. Make sure the location has power and internet access, as well as a rack or 19” shelf for the gateway.
c. Contract an ISP (Internet Service Provider) to bring internet connectivity to the closet.
d.MakesurethattheinternethassufcientbandwidthfortheGateway.
i. The minimum bandwidth is 3Mbps down.
ii. Recommended is a bandwidth of 1Mbps down for every 4 Touchscreens.
2. Perform a Site Survey to determine the Access Point Needs of the facility.
a. There are four basic steps to design a wireless network.
i. Identifying areas that need coverage and estimating the number of APs needed.
ii. Running cable from the communications closet to the APs mounting locations.
iii. Mounting the APs.
iv. Coverage Check
To Next Page
Loading...
Need help?
General
