Matrix Visionpro - DID; DOSA; Trunk Landing Destination for Day Mode

12 Matrix VISIONPRO Quick Start
Trunk is from 0 to 2.
Enable/Disable flag codes are,
0 for Disable
1 for Enable
Dial type can be either Pulse or Tone where corresponding flag codes are,
0 for Pulse
1 for Tone
DID
To configure a trunk for DID calls,
•Dial 43-Trunk-Day Code-Night Code
Where,
Trunk is from 0 to 2
Day Code/Night Code flags are,
0 for Disable
1 for Enable
DOSA
To configure a trunk for DOSA calls,
•Dial 45-Trunk-Day Code-Night Code
Where,
Trunk is from 0 to 2.
Day Code/Night Code flags are,
0 for Disable
1 for Enable
Trunk Landing Destination for Day Mode
To assign the Trunk Landing Destination for Day Mode,
•Dial 47-Trunk-Ext1-Ext2-Ext3-Ext4
To assign the Trunk Landing Destination for Day Mode for all trunks at once,
•Dial 47-*-Ext1-Ext2-Ext3-Ext4
Where,
Trunk is from 0 to 2.
Ext1 to Ext4 are the flexible numbers of destination stations. Flexible number can be of 1,2,3
or 4 digits. Maximum four destinations can be programmed for a single trunk.