USA
FCC Compliance Statement
Remark for the Matrox hardware products supported by this guide This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
WARNING Changes or modifications to this unit not expressly approved by the party responsible for the compliance
could void the user’s authority to operate this equipment. The use of shielded cables for connection of the monitor to
the card is required to meet FCC requirements.
CANADA
(English) Innovation, Science and Economic Development Canada
Remark for the Matrox hardware products supported by this guide These digital apparatus does not exceed the
Class A limits for radio noise emission from digital devices set out in the Radio Interference Regulation of Industry
Canada.
(Français) Innovation, Sciences et Développement économique Canada
Remarque sur les produits matériels Matrox couverts par ce guide Ce present appareil numérique n’émet aucun
bruit radioélectrique dépassant les limites applicables aux appareils numériques de Classe A prescrites dans le
Règlement sur le brouillage radioélectrique édicté par Industrie Canada.
USA
(English) FDA (Food and Drug Administration) requirements for Laser Products
Remark for the Matrox hardware products supported by this guide This product includes a 850 nm Laser
Product compliant to 21CFR Subpart J Class 1.
KOREA
A 급 기기 ( 업무용 방송통신기자재 )
이 기기는 업무용 (A 급 ) 전자파적합기기로서 판 매자 또는 사용자는 이 점을 주의하시기 바
라 며 , 가정외의 지역에서 사용하는 것을 목적으 로 합니다 .
EUROPE
(English) European user’s information – Declaration of Conformity
Remark for the Matrox hardware products supported by this guide These devices comply with EC
Directive 2014/30/EU for a Class A digital device. They have been tested and found to comply with
EN55032/CISPR32 and EN55024/CISPR24. In a domestic environment these products may cause radio interference in
which case the user may be required to take adequate measures. To meet EC requirements, shielded cables must be
used to connect the monitor and other peripherals to the card. These products have been tested in a typical class A
compliant host system. It is assumed that these products will also achieve compliance in any class A compliant system.
(Français) Informations aux utilisateurs Européens – Déclaration de conformité
Remarque sur les produits matériels Matrox couverts par ce guide Ces unités sont conformes à la directive
communautaire 2014/30/EU pour les unités numériques de classe A. Les tests effectués ont prouvé qu’elles sont
conformes aux normes EN55032/CISPR32 et EN55024/CISPR24. Le fonctionnement de ces produits dans un
environnement résidentiel peut causer des interférences radio, dans ce cas l’utilisateur peut être amené à prendre les
mesures appropriées. Pour respecter les impératifs communautaires, les câbles de connexion entre le moniteur ou
autres périphériques et la carte doivent être blindés. Ces produits ont été testés dans un système hôte typique
compatible classe A. On suppose qu’ils présenteront la même compatibilité dans tout système compatible classe A.
To Next Page
Loading...
