SmartDrive User’s Manual 1
Intended Use of the SmartDrive
e Max Mobility SmartDrive Wheelchair Power Assist device is exclusively intended to provide auxiliary power to manual
wheelchairs to reduce the pushing power needed by their users, including pediatrics, with a user weight of 30 to 331 lbs
(14 - 150 kgs). It is intended to be used by users capable of operating and maneuvering a powered and manual wheelchair,
ultimately empowering them through enhanced mobility. It is also very strongly recommended that it be used on manual
wheelchairs that meet the “Wheelchair Compatibility” dimensions listed in the Specication Sheet.
Must Read Prior-to-Use Information
Improper use of the SmartDrive or the wheelchair it is attached, depending on surface, weather, and trac conditions, can
present a potential of injury and cause damage to the wheelchair or SmartDrive. erefore, the SmartDrive must only be
handled and used under the following prerequisites:
• e user is both physically and mentally capable of operating the wheelchair and device in all possible conditions
and situations. [Contraindication]
• Proper instruction on its handling and operation has been received by reading and understanding this user’s manual
in its entirety.
• No technical modications have been made to the device.
• e user must take time to become accustomed to the SmartDrive’s response and performance by rst practicing
its operation in a safe area that is free from hazards. One should become familiar with the tap sensitivity, push
recognition, deactivation response, acceleration / top speed, etc. of the device before venturing out with the device,
where potentially hazardous situations may exist. It is strongly recommended that the user not attempt to use the
SmartDrive outdoors until it can be safely operated indoors without diculty.
If any issues or malfunctions exist, cease the use of the SmartDrive and contact Max Mobility for service / further instruction.
Any contrary use to the directions of this user’s manual, to the recommendations of one’s mobility equipment dealer, or to
the technical limitations dened by either Max Mobility and one’s wheelchair manufacturer is considered to be misuse of the
SmartDrive. Max Mobility is not responsible for any injuries or damage caused by this type of misuse.
Warnings and Safety Precautions
All warnings and safety precautions issued by one’s wheelchair manufacturer must be heeded in addition to
those stated in this manual. Failure to do so could result in serious injury or death.
Handling or use of the SmartDrive by anyone who
has not received proper instruction from this manual
1. Introduction
come accustomed to this new feeling.
Always inspect your SmartDrive, PushTracker, attach-
ment hardware and the optional thumb throttle buttons for
missing parts / damage prior to each use [see the “Mainte-
nance” section(s) for parts to pay attention to].
Make sure both the SmartDrive and PushTracker are
charged before use.
Always pay close attention to the surface that you are op-
erating your wheelchair, whether your SmartDrive is on or
not, as the front casters of your wheelchair can get stuck in
e specications provided by one’s wheelchair manufac-
turer may be slightly aected by the addition of the
SmartDrive.
cracks, ruts, holes, ledges, etc. Running into these obsta-
cles can cause you to tip out of your chair.
may result in serious injury or death.
Do not attempt to attach the SmartDrive to a wheelchair
that does not meet the dimensions outlined in “Wheel-
chair Compatibility” section of the Specication Sheet.
One MUST familiarize themselves with the response and
performance of the SmartDrive prior to regular use. Do
not attempt to use outdoors until it can be safely operated
indoors without colliding into walls or any other objects.
Methods for safe use of a SmartDrive attached wheelchair
are dierent for each user depending on function and ability.
e addition of the SmartDrive to one’s wheelchair
may cause it to feel dierent. Take the time to be-
(Continued on next page)
To Next Page
Loading...
