TWO THRUSTERS SET-UP (1
st
RECEIVER)
Connect the receiver to the power supply
12/24V
To activate 2 commands simultaneously
press the 2 buttons* to be activated
Æ The LED will ash.
These commands are now activated
and paired to outputs 1 & 2
Turn the power supply ON
Æ The LED ashes once
Turn the receiver OFF (for 5 seconds)
To activate other commands return
to step 2.
Outputs will be activated in their
numerical order in pairs.
Gently press the SYNC button (just once)
using a small screwdriver
Æ The LED lights up
16
To Next Page
Loading...