-13-
ABOUT THE MACHINE SPECIFICATIONS
AC ADAPTER INFORMATION
1. The stapling capacity described in the product specifications is exerted when copy paper (64 g/㎡)
is used. This number of sheets may not be stapled depending on the type of paper. In that case,
do not staple by force.
2. If the machine is used continuously for a long time, the motor may overheat, disabling stapling
operation. In that case, stop using the machine for 30 minutes or more to cool down the motor.
3. When replacing batteries, replace all six batteries with new ones. Also, discard the used batteries
according to the method specified by the local government.
4. In case free staples enter inside the body of the device accidentally, remove them by tilting the device.
REQUEST
FCC Notice
(Class B: BH-11F)
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Manufacturer’s name or trade mark,
commercial registration number and address
Model identifier
Input voltage
Input AC frequency
Output voltage
Output current
Output power
Average active efficiency
Efficiency at low load(10%)
No-load power consumption
6A-401DA12
AC100-240V
50-60Hz
DC12.0V
3.0A
36.0W
87.4%
75.0%
0.10W
MAX EUROPE B.V. 39093032
Antennestraat 45, 1322 AH Almere, The Netherlands
Phonenumber : (31)36-546-9669
COMMISSION REGULATION (EU) 2019/1782 of 1 October 2019
Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference t
o radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Model name
2 to 40 sheets (64gsm/55kg)
Stapling capacity
Loading capacity
Working temperature
and humidity range
Type of clinch
Weight
Power source
Usable staple MAX No.11-1M staples
Temperature: For AC adapter, 10ºC/50ºF to 35ºC/95ºF
For Battery, 15℃/59ºF to 35ºC/95ºF
Humidity: Below 80% RH (non-condensation)
1.
DC12V, 3A Use only specified
AC adapter (AC100-240V, 50-60Hz)
appended to machine.
2. Alkaline AA Batteries x 6
860 g (1.89 lbs)
Throat depth
Dimensions
W69 x D163 x H129 mm
(2-23/32" x 6-7/16" x 5-3/32")
Parallel stapling: Approx.
3 to 15 mm (1/8" to 19/32")
Corner stapling: Approx.
18 to 30 mm (23/32" to 1-25/32")
Flat clinch
100 staples
MAX Battery Stapler BH-11F
To Next Page
Loading...
