Max ER-1500 - Setting Work Times and Overtime (Mode 3)

- 15 -
Procedure
1. Setting IN & OUT and starting time of Overtime Work
[Example] Line Shift Time (Day change time) : 4 : 00
Starting time of work : 9 : 00
Starting time of lunch : 12 : 00
Ending time of lunch : 13 : 00
Ending time of work : 17 : 00
Starting time of Overtime work : 17 : 30
Procedure [MODE 3] Display
Press the “IN2” key.
Current Line Shift Time is shown on the display.
Press the or key until the display shows “4:00.”
Press the “SET” key to register the Line Shift Time.
Press the or key until the display shows “9.”
Press the “SET” key to register the Hour for “IN1.”
Press the or key until the display shows “00.”
Press the “SET” key to register the Minute for “IN1.”
Press the or key until the display shows “12.”
Press the “SET” key to register the Hour for “OUT1.”
Press the or key until the display shows “00.”
Press the “SET” key to register the Minute for “OUT1.”
Press the or key until the display shows “13.”
Press the “SET” key to register the Hour for “IN2.”
Press the or key until the display shows “00.”
Press the “SET” key to register the Minute for “IN2.”
Press the or key until the display shows “17.”
Press the “SET” key to register the Hour for “OUT2.”
Press the or key until the display shows “00.”
Press the “SET” key to register the Minute for “OUT2.”
Press the or key until the display shows “17.”
Press the “SET” key to register the Hour for “OST.”
Press the or key until the display shows “30.”
Press the “SET” key to register the Minute for “OST.”