To Next Page
E
Emily ParkerAug 17, 2025
What to do if my Max Clock ER-1600 printer malfunction?
- JJoseph SwansonAug 17, 2025
If your Max Clock ER-1600 printer malfunctions, try to get a normal printout by disconnecting and then reconnecting the power cord.
What to do if my Max Clock ER-1600 printer malfunction?
If your Max Clock ER-1600 printer malfunctions, try to get a normal printout by disconnecting and then reconnecting the power cord.
Why Max Clock ER-1600 has no print out on time card?
If there is no print out on the time card from your Max Clock ER-1600, check if the ink ribbon cassette is inserted correctly.
What to do if automatic feed does not carry time card smoothly in Max Clock ER-1600?
If the automatic feed does not carry the time card smoothly in your Max Clock ER-1600: * Do not hold the time card during printing. * Check if the time card is bent or damaged.
What to do if card insertion is obstructed in Max Clock ER-1600?
If card insertion is obstructed in your Max Clock ER-1600, verify the following: * Is the card being inserted on the correct side? * Is the card bent or damaged?
Why is the printout faint on my Max Clock ER-1600?
If the printout is faint on your Max Clock ER-1600, consider the following: * Is the ink ribbon being used for too long? * Is the ink ribbon cassette inserted correctly?
Why is there deviation in the printing line position on my Max Clock ER-1600?
If there is deviation in the printing line position on your Max Clock ER-1600, check the following: * Is the card being inserted too strongly? * Are you pulling out the card during the printing process? * Are you holding the card when it is automatically being pulled inside? * Is the card damp?
What to do if the Max Clock ER-1600 cannot read holes on time card correctly?
If your Max Clock ER-1600 cannot read the holes on the time card correctly, check if any holes are covered and if the time card is bent or damaged.
What to do if I insert time card used last month in Max Clock ER-1600?
If you insert a time card used last month into the Max Clock ER-1600, use a new time card instead.
What to do if time card is not inserted far enough in Max Clock?
If the time card is not inserted far enough into your Max Clock to where the automatic feed activates, insert the time card until the automatic feed starts.
What to do if I insert time card on the wrong side in Max Clock?
If you've inserted the time card on the wrong side of your Max Clock, insert the time card on the other side.
Provides warnings and cautions for safe operation and proper use of the instrument.
Details the step-by-step procedures for setting specific items in MODE 1.
Details how to set a 4-digit password for security.
General
