- 10 -
SETTING MODE 1
Press “MODE 1” key after pressing the “CANCEL” key for 3sec. or more.
If password has been set up, enter the password before into the setting mode.
MACHINE MODE 1 (CODE 01)
Press or to select a desired number from the following table and set “Capacity of Employees.”
According to the number, each function will be activated.
◆ Initial data=1
Number
Capacity of
Employees
Function Printed result on Time Card
Daily Total Hours Next Day Overtime 5
th
column 6
th
column
1 60 Use Use
Daily Total
Hours
Accumulation of
Daily Total Hours
2 130 Use Not use
Daily Total
Hours
Accumulation of
Daily Total Hours
3 150 Not use Use Time
Time
1. When selecting “1,” you cannot use “IN3” and “OUT3” external keys.
When pressing these keys, “E-90” appears on the display.
2. When selecting “2,” you cannot use “IN3,” “OUT3” and “Next Day Over-
time( )” keys. When pressing these keys, “E-90” appears on the display.
MACHINE MODE 2 (CODE 02)
Press or to select a desired number from the following table and set “12/24-Hour Format”
and “Pay Period.”
◆ Initial data=1
Number 12/24-Hour Format Pay Period
1
12H
Monthly
2
24H
3
12H
Weekly
4
24H
5
12H
Bi-weekly
6
24H
1. The time is printed only in 24-hour format.
2. When setting in the “Laid Down Position,” only 24-hour format is displayed.
To Next Page
Loading...