i-SHWAK V4 Inverter air/water chillers and heat pumps with wall-mounted indoor unit and remote condensing outdoor unit
42
22 ACCESS PROCEDURE TO INTERNAL PARTS
22.1 INDOOR UNIT
1) Remove the four screws on the top and bottom of the
unit.
2) Remove the front panel.
22.2 OUTDOOR UNIT
22.2.1 Mod. i-SHWAK V4 06 / 08
1) Remove the top cover
2) Twist off the screws (number 2; 3; 4) of the user interface cover plate and the screw (1) from the side panel for separating
the side panel from the front panel (Detail A).
3) Sequentially, twist off the screws (number 5; 6; 7) in order to move shift slightly the front panel and gain access to the
screw (number 8) visible in detail B.
4) Twist off the screws (number 8; 9 visible in detail B) and those positioned on the battery side of the unit. To remove the
side panel, pull it up (in order to free the tab of the base coupling which is indicated as C in detail B) and remove it.
To Next Page
Loading...
