Wiring
Wiring Figure
NOTE: Refer to the following figures if end-users wish to perform their own wiring.
CAUTION
Connect the connective cables to the terminals, as identified, with their matching numbers on the
terminal block of the indoor and outdoor units. For example, in the US models shown in the
following diagram, Terminal L1(A) of the outdoor unit must connect with terminal L1 on the
indoor unit.
Run the main power cord through the lower line-outlet of the cord clamp.
models: 1 x 2 DC INVERTER (Dual)
Model A
Model E Model F Model G
Model B Model C Model D
Magnetic ring ( not supplied, optional part)
(Used to hitch to the connective cable of indoor
and outdoor units after installation.)
Page 17
To Next Page
Loading...
