Maxcom MM29D 3G User Manual

14
Inserting the SIM Card while the phone is switched on might damage the
phone.
Move the SIM Card slot pin to the left, and fold it back. Slide the SIM
Card into the slot so that its golden contacts will face downwards with
the notched corner next to the battery contacts. Lock the pin, and move
it to the right. Place the battery cover back into position and switch on
the phone.
Any settings and data stored on the Card and in the phone might be lost
after removing the battery. Remove the battery only with the phone
switched off; otherwise the phone might malfuntion.
6.2 Battery Installation
Plug out the AC Adapter. Remove the battery cover and the SIM Card
located in the back of the phone. Use a screwdriver (or something
similar) to gently open the latch in the cover, see the figure in the point
6.1.
Connect the battery; pay attention to the notches on the plug and the
socket; the red wire should be placed from the upper side of the phone.
Place the battery on the right hand side of the opening, and place the
cover back into position.

Maxcom MM29D 3G Specifications

General

Type	DECT telephone
Product color	Black
Display diagonal	2.8 \
Display resolution	128 x 64 pixels
Compatible memory cards	Not supported
WAP	Yes
Data network	-
3G bands supported	900, 1800 MHz
SIM card capability	Single SIM
2G bands (primary SIM)	900, 2100 MHz
Mobile network generation	3G
Multimedia Messaging Service (MMS)	Multimedia Messaging Service (MMS) is a standard way to send messages that include multimedia content to and from a mobile phone over a cellular network
Talk time (2G)	2 h
Battery capacity	600 mAh
Standby time (2G)	120 h
Subscription type	No subscription
Phonebook capacity	600 entries

Weight and Dimensions

Depth	206 mm
Width	164 mm
Height	100 mm
Weight	624 g