Maxeon Sunpower - Handling of Modules During Installation

MAXEON SOLAR TECHNOLOGIES, LTD.
Safety and Installation Instructions - Document 001-15497 Rev.V
© August 2021 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this manual are subject to change without notice.
temperatures. Fingerprints, stains, or accumulations of dirt on the
front surface may be removed as follows: first rinse off area and let
soak for a short period of time (5 mins). Re-wet and use a soft sponge
or seamless cloth to wipe glass surface in a circular motion.
Fingerprints typically can be removed with a soft cloth or sponge and
water after wetting. Do not use harsh cleaning materials such as
scouring powder, steel wool, scrapers, blades, or other sharp
instruments to clean the glass surface of the module. Use of such
materials or cleaning without consultation will invalidate the product
warranty. As dry cleaning is also risky for Anti-Reflective (AR) coated
module surface, spinning brush is not recommended for module
cleaning.
Table 2: Module Frame Details
Platform
Module mounting and ground hole detail
Frame Profile
RESIDENTIAL G3 FRAME ONLY
Residential
Modules
96 CELL MODULE FRAME DETAIL
SIDE FRAME PROFILE
END FRAME PROFILE
FOR COMMERCIAL (SILVER FRAME) MODULES ONLY, INCLUDES STACKING PINS
Commercial
Modules
96 CELL COMMERCIAL MODULE
128 CELL COMMERCIAL MODULE
SIDE FRAME PROFILE
With Stacking Pins
END FRAME PROFILE
Method 1:
Frame Hole
Locations
Method 1:
Frame Hole
Locations
Measurement Tolerances are +/-3 mm for the Length and Width of the Module.