14
M-70
Pedals
Step 4：Install the pedals.
1.The right pedal (an “R” stuck on the pedal as shown) is
threaded to tighten by turning clockwise (toward the trike’s
front). Carefully thread the right pedal onto the crank on the
right side of the bike slowly and by hand. Do not cross thread
or damage the threads.
2.The left pedal (an “L” marked on the
pedal as shown) is reverse-threaded and
tightens counterclockwise (toward the
trike’s front). Carefully thread the pedal
onto the left crank by hand slowly. Do not
cross thread or damage the threads.
3.After tightening the pedal with your
hand, you also need to use the 18 mm
Allen key of the tool kit to attach and
tighten the pedals to prevent stripping.
L
R
To Next Page
Loading...
