16
M-70
Other Parts
Step 6: Inflate the tires
Use a pump with a pressure gauge to inflate and inflate the tires with the recommended air pressure that is
located on the sidewall of every tire.
Please note that do not over inflate or under-inflate.
Step 7: Set the desired seat height
Open the quick release lever by hinging it open fully. Ensure the seatpost clamp opening is aligned with the
notch at the front of the seat tube. Adjust the seatpost up or down to a comfortable height,
while ensuring the seatpost is inserted into the frame past the minimum insertion point.
If needed, use the thumb nut to add tension to the clamp so there is some resistance when the lever is in line
with the clamp bolt, but do not overtighten.
Close the quick release lever to secure the seatpost and check that it cannot move. See the Adjusting the Seat
section of this manual for more details.
Step 8: Always check that the battery is locked to the frame of the trike before
riding
The Start-Up Procedure section shows more information on the key positions of the battery; on and locked
to the frame, off and locked to the frame, and off and unlocked (ready for removal from the frame). Operate
the electrical system when the battery has been adequately charged and the battery is secured to the
mounting receptacle on the frame.
To Next Page
Loading...