&
8
To Use
16 To Use Restraint
System
Unbuckle restraint system
by pressing center button
(Figure 16). Place your
child in the stroller, with
the crotch strap between
the child’s legs. Fit clips
together (Figure 16a).
Slide clips into buckle
until you hear a “click”
(Figure 16a).
Tighten straps snugly
around your child (Figure
16b). Re-thread the restraint system if needed, exactly as shown in figure 16c.
WARNING
• NEVER LEAVE CHILD UNATTENDED. ALWAYS keep child in view when in stroller.
• AVOID SERIOUS INJURY from falling or sliding out. ALWAYS use seat belt. Check frequently to make sure it is
secure. Belts must be threaded exactly as shown (Figures 16c and 16d).
• Failure to follow these instructions could result in the serious injury or death of your child.
15 Adjust Restraint Height
The shoulder straps have three height positions for your growing child.
Push each anchor through the seat back and into the desired slot
(Figure 15). Be sure the anchors lay flat against the seat back. NOTE: Be
sure the four anchors lay flat against the seat back (Figure 15).
WARNING:
• For proper installation of the restraint system, make sure all four (4) anchors
lay flat against the back board. • NEVER use stroller without BOTH restraint
and crotch straps. WHEN SEATED, the midpoint of the child’s head is at or below the top of the stroller seat.
16
16a
16b
16c
15
4 Anchors
To Next Page
Loading...
Need help?
General
