&
3
Assembly
4 Install as a Carriage
NOTE: The carriage
may face forward or
toward the handlebar (Figure 4).
Unfold carriage (Figure 4a). Ensure clip
behind the leg rest is detached (Figure 6d).
Lower seat/carriage onto hubs until you
hear each side “click” (Figure 4b). Pull up to
confirm seat is assembled securely.
NOTE: See page 4, step 6 to convert seat to
carriage mode.
4a 4b
4
OK
OK
Hubs
WARNING
• Child may slip into leg openings and strangle. Always use carriage in reclined position.
• DO NOT use stroller in reclined carriage position with an older child that can lift up
on hands and knees.
5
5 Install as a Seat
Unfold seat/carriage until it clicks.
Lower seat onto hubs
until you hear each
side “click” (Figure 5). Pull up to confirm seat
is assembled securely.
NOTE: Seat may face forward or toward the
handlebar.
To remove seat: Press upward on release
buttons on both sides while lifting seat off
frame (Figure 5a). Reverse seat and lower
onto hubs until you hear each side “click.”
NOTE: See page 4, step 6 to convert carriage
to seat mode.
5a
5b
OK
OK
2x
To Next Page
Loading...
Need help?
General
