Remove Slack from Seatbelt
PullPush
Figure 12
30
Rear Facing Mode Install using Seatbelt
Figure 13
Figure 14
Figure 15
Remove Slack from Seatbelt
Step 1. Press the restraint down rmly into the
vehicle seat (Figure 12).
Step 2. Remove belt slack by pulling on the sash
portion of the belt so the lap portion is taught.
Step 3. Remove all the slack rst from the lap
and sash belts before operating the SMART
Lock
®
(see following step).
Close SMART Lock
®
and restore seat fabric
Step 1. Press the clamp handle down
rmly to tighten and lock the vehicle
seat belt installation (Figure 13).
Step 2. Ensure both tension indicators
show green after locking the SMART
Lock
®
(Figure 14).
NOTE: Indicators will stay black if
installed incorrectly.
Step 3. Close installation door, button
up seat trim and re-install infant
inserts (if in use) (Figure 15.)
IMPORTANT:
Always remove slack from seatbelt.
A loose seatbelt is dangerous.
To Next Page
