No twists
Store
Strap
Figure 2 Figure 3
Figure 1
32
Rear Facing Mode Install using Seatbelt
Remove
Slack
Remove slack from top tether
Step 1. Remove slack only. Do not
over-tighten the top tether strap so
that the restraint lifts up off the vehicle
seat (Figure 1).
Step 2. Ensure there are no twists
and turns in the top tether strap and
that the adjuster is positioned facing
outwards, at against the restraint
(Figure 2).
Step 3. Roll up excess strap and store
in the pocket provided on the cover
(Figure 3).
IMPORTANT:
Always remove slack from top tether.
A loose top tether is dangerous.
Loosening the top tether
Step 1. Press top tether adjust button
(grey - Figure 2)
Step 2. Simultaneously, pull the tether
strap through the adjuster to loosen as
required.
WARNING
DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR.
To Next Page
