35
Rear Facing Mode
Pull
Tighten the harness
Step 1. Before pulling on adjuster
strap to tighten harness, pull on
harness shoulder straps rst to
remove slack from the waist area
(Figure 8).
Step 2. Once slack is removed, pull on
adjuster strap so that the harness over
the shoulders is rm (Figure 9).
Step 3. Pinch the straps near the top
of the shoulder to check for correct
tment. This is achieved when you are
unable to pinch the harness (Figure
10). If you can pinch the harness,
tighten more.
Step 4. You may need to use a ratchet
motion after tightening to remove
additional slack.
Pinch
Test
Figure 8 Figure 9
Figure 10
TIP Always use the Pinch test
when you buckle your child
as your harness may need
adjusting.
DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR.
WARNING
To Next Page
