Tongue Buckle
No twists
53
Forward Facing Mode
Place child in the restraint
Step 1. Place child in the seat, t
harness straps over child’s shoulders
and position buckle between child’s
legs (Figure 18).
Step 2. Insert harness tongues into
the harness buckle, listen for ‘click’
(Figure 19).
Step 3. Pull on harness straps to
ensure proper engagement
Step 4. Ensure there are no twists.
click
Figure 20
Figure 21
Set headrest
and harness height
Step 1. Re-adjust headrest and
harness height until correct
height is reached for your child
(Figure 20).
Step 2. The shoulder straps must
be in the slots which are nearest
to the child’s shoulders but not
more than 25mm below the
child’s shoulders. (Figure 21).
Figure 19
Figure 18
Harness
straps in
green zone
Always adjust the height of the shoulder straps as the
child grows
To Next Page
