Maximum 055-6766-2 - Page 10

ASSEMBLY
KNOW YOUR TABLE SAW
• Inspect the workpiece for knots or nails before beginning a cut. Knock out any loose
knots with a hammer. Never saw into a loose knot or nail.
• Always use the rip fence when rip cutting and the mitre gauge when crosscutting. This
helps to prevent twisting the wood in the cut.
• Always use clean, sharp, and properly set blades. Never make cuts with dull blades.
• To avoid pinching the blade, support the work properly before beginning a cut.
• When making a cut, use steady, even pressure. Never force cuts.
• Do not cut wet or warped lumber.
• Always hold the workpiece firmly with both hands or with push sticks. Keep your body
in a balanced position to be ready to resist kickback should it occur. Never stand
directly in line with the blade.
• Use the right type of blade for the cut being made.
model no. 055-6766-2 | contact us 1-888-670-6682model no. 055-6766-2 | contact us 1-888-670-6682
1918
PACKAGE CONTENTS
No. Description Qty Illustration
Table saw assembly
Blade guard assembly
Anti-kickback pawls assembly
Rip fence
Mitre gauge
Outfeed support
Extension poles, stop screws
and pole stopper bolts
Push stick
1
2
3
4
5
6
7
8
1
1
1
1
1
1
2
1